درایور موتور ۳۰ آمپرVNH2SP30

درایور موتور ۳۰ آمپرVNH2SP30 ، قادر به جریان دهی  مداوم  ۳۰ A  نمی باشد.

FULL BRIDGE

Description:
This IS Essentially A ramped up Version of the For Our Ardumoto Motor Driver Shield Shield We’ve REPLACED the this Monster at The L298 H-Bridge A pair of VNH2SP30 the with Full-Bridge Motor Also the Drivers We’ve beefed up at The Support Circuitry SO. this board is capable of driving a pair of high-current motors! The VIN and motor out are pitched for our 5mm screw terminals (not included), making it easy to connect larger gauge wires.

Note:
the When a using the this Board in Extreme High-Demand Applications IT May BE Necessary to Improve Thermal Performance the with A Heat-Sink or Fan and to Solder at The Wires Directly to at The Board INSTEAD of a using A Screw Terminal (in Addition to at The Myriad OTHER Complications present in a high-current system) However, when using the board at currents up to 6A the chips will barely become noticeably warm.

Features:
Voltage max: 16V
Maximum current rating: 30 A
Practical Continuous Current: 14 A
Current sensing available to Arduino analog pin
MOSFET on-resistance: 19 mΩ (per leg)
Maximum PWM frequency: 20 kHz
Thermal Shutdown
Undervoltage and Overvoltage shutdown

Interface definition:
۱٫PWM: Speed ​​Interface
۲٫INB: Reversible logic B interface (see the logic of the data sheet)
۳٫INA: A Reversible logic interfaces (see Data Sheet logic)
۴٫CS: limiting resistor (board Received)
۵٫EN: enable terminal, A and B enable terminals are connected together
۶٫GND: public land
۷٫۵V: External 5v, can directly enable end EN.

DC motor connected by a simple method to test module:
۱٫PWM directly connected 5v DC, doing full control
۲٫INB then high, INA then low, and vice versa, then the reverse;
۳٫CS, EN is not connected
۴٫GND and 5V external ground and 5V power supply;
۵٫ Enter the power supply Vcc connected to 5V, the output pin is directly connected to the two ends of the DC motor;

برای اطلاعات بیشتر اینجا کلیک کنید.

•   3.3 - 16 V
•   14 A